|
Still waiting for the wall boards and roof timber to be delivered, so today I decided to try to make one of the three louvred vents which will be placed at each of the three gable ends. This is easier than you might think, but you do need an electric mitre saw, which makes life a lot easier.
I measured and cut these pieces after I'd made the frame, to make sure they would all fit snugly. I think this picture shows me sanding the cut edge - the saw blade I was using tended to splinter the very end of the wood. The pieces just slot in and are then nailed. I used a nail gun with 35mm brads, nailed through the frame and into the louvres, left and right, front and back.
|
|
Back Next
|
|
